Author : William Thomas Mozet
Publisher :
ISBN 13 :
Total Pages : 196 pages
Book Rating : 4.:/5 (974 download)
Book Synopsis Investigation of Fundamental Growth Mechanisms in Pulsed Laser Deposition Synthesis of Nanostructured Materials by : William Thomas Mozet
Download or read book Investigation of Fundamental Growth Mechanisms in Pulsed Laser Deposition Synthesis of Nanostructured Materials written by William Thomas Mozet and published by . This book was released on 2016 with total page 196 pages. Available in PDF, EPUB and Kindle. Book excerpt: Studies are conducted to better understand growth mechanisms in pulsed laser deposition (PLD) synthesis of nanostructured materials, namely graphene and bismuth telluride (Bi2Te3). For graphene, as the substrate temperature increases, the order of the film increases, from an amorphous carbon film to nanocrystalline graphite and few-layer graphene (FLG). By using a high energy laser, the size and type of ablated species can be controlled to create films with smaller nanocrystalline domains. PLD allows the thickness of the films to be directly controlled by the deposition duration. Films can be grown on arbitrary substrates, unlike other methods which utilize surface chemistry. Substrate morphology also affects the samples, with higher surface roughness leading to larger D/G and 2D/G ratios. Polishing substrates prior to deposition can decrease these ratios by up to 15%. Here, the type of carbon source has little impact on sample growth, except in atmospheric growth of graphene, which may not be an optimal condition because of energy loss of the carbon species. In-situ plasma plume analysis is conducted to analyze the species being ablated from the target. Ablated species consist primarily of C+ ions, with some neutral C and C2 species. Ablated C+ ions are at temperatures as high as 12,000 K in vacuum and 10,000 K in 0.1 torr argon. For bismuth telluride, optimal growth conditions are found for the stoichiometric transfer of Bi2Te3, which can vary from system to system. In general, a deposition temperature of 200°C and a deposition pressure of 0.1 to 1.0 torr argon are required for stoichiometric transfer. Using a high energy laser for ablation leads to smaller grain sizes in the nanostructured films. In addition, using a nitrogen atmosphere instead of argon leads to increased gas-phase condensation prior to deposition, resulting in a highly featured surface. When outside of the ideal pressure range, the substrate material can significantly affect the surface morphology of the sample, ranging from smooth films to nanoparticles and nanorods. These morphologies affect the electrical properties of the material. In general, the lowest electrical resistance came from films grown using 532 nm laser irradiation, which leads to larger grain sizes and more featured surfaces. Films grown at slightly reduced pressure, which leads to more featured surfaces, are also low in electrical resistance. These films also have large Seebeck coefficients, both of which lead to a higher thermoelectric figure of merit.
