Read Books Online and Download eBooks, EPub, PDF, Mobi, Kindle, Text Full Free.
Analytic And Experimental Performace Of Two Isentropic Mixed Compression Axisymmetric Inlets At Mach Numbers 08 To 265
Download Analytic And Experimental Performace Of Two Isentropic Mixed Compression Axisymmetric Inlets At Mach Numbers 08 To 265 full books in PDF, epub, and Kindle. Read online Analytic And Experimental Performace Of Two Isentropic Mixed Compression Axisymmetric Inlets At Mach Numbers 08 To 265 ebook anywhere anytime directly on your device. Fast Download speed and no annoying ads. We cannot guarantee that every ebooks is available!
Book Synopsis Analytic and Experimental Performance of Two Isentropic Mixed Compression Axisymmetric Inlets at Mach Numbers 0.8 to 2.65 by : Donald B. Smeltzer
Download or read book Analytic and Experimental Performance of Two Isentropic Mixed Compression Axisymmetric Inlets at Mach Numbers 0.8 to 2.65 written by Donald B. Smeltzer and published by . This book was released on 1973 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt: A mixed compression axisymmetric inlet model with a capture diameter of 50 cm was tested at Mach numbers ranging from 0.8 to 2.65 at 0 deg angle of attack and a constant total pressure of approximately 1 atm. Analytical methods accounting for the effects of both viscous and inviscid flows and incorporating empirical bleed discharge coefficients were used in the procedure for designing the inlet contours and the bleed system. Experimental results are compared with analytic predictions and are also compared with results from earlier tests of an inlet with the same internal contours but with a bleed system developed by cut and try methods in the wind tunnel. With the bleed configuration predicted by the design procedure, maximum total pressure recovery at the engine face at the design Mach number of 2.65 was 93 percent, with a total pressure distortion less than 10 percent. Corresponding bleed mass flow was approximately 7.5 percent, which was about 1.3 percent less than predicted. At lower supersonic Mach numbers, pressure recovery and bleed were generally lower and distortion generally higher.
Book Synopsis Analytic and Experimental Performace of Two Isentropic Mixed Compression Axisymmetric Inlets at Mach Numbers 0.8 to 2.65 by : Donald B. Smeltzer
Download or read book Analytic and Experimental Performace of Two Isentropic Mixed Compression Axisymmetric Inlets at Mach Numbers 0.8 to 2.65 written by Donald B. Smeltzer and published by . This book was released on 1973 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Performance of Three Isentropic All Internal Compression Axisymmetric Inlets Designed for Mach 2.5 by : Bernhard H. Anderson
Download or read book Performance of Three Isentropic All Internal Compression Axisymmetric Inlets Designed for Mach 2.5 written by Bernhard H. Anderson and published by . This book was released on 1960 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Performance of Three Isentropic All Internal Compression Axisymmetric Inlets Designed for Mach 2.5 by :
Download or read book Performance of Three Isentropic All Internal Compression Axisymmetric Inlets Designed for Mach 2.5 written by and published by . This book was released on 1960 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Experimental Investigation of a Large-scale, Two-dimensional, Mixed-compression Inlet System by : Norman D. Wong
Download or read book Experimental Investigation of a Large-scale, Two-dimensional, Mixed-compression Inlet System written by Norman D. Wong and published by . This book was released on 1971 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt: A large-scale, variable-geometry inlet model with a design Mach number of 3.0 was tested at Mach numbers from 1.55 to 3.2. Variable features of the inlet for off-design operation are an adjustable-height ramp system and a translating cowl. This report presents experimental results for a diffuser and boundary-layer bleed configuration which was optimized at the design Mach number. Overall performance was high with throat-mounted vortex generators, which were effective in reducing flow distortion in the subsonic diffuser at the higher Mach numbers.
Book Synopsis Investigation of a Nearly Isentropic Mixed-compression Axisymmetric Inlet System at Mach Numbers 0.6 to 3.2 by : Donald B. Smeltzer
Download or read book Investigation of a Nearly Isentropic Mixed-compression Axisymmetric Inlet System at Mach Numbers 0.6 to 3.2 written by Donald B. Smeltzer and published by . This book was released on 1968 with total page 162 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Performance Summary and Analysis of a Mach 3.0 Design Axisymmetric All-external-compression Double-cone Inlet Mach Number Range 3.0 to 0.8 by : John L. Allen
Download or read book Performance Summary and Analysis of a Mach 3.0 Design Axisymmetric All-external-compression Double-cone Inlet Mach Number Range 3.0 to 0.8 written by John L. Allen and published by . This book was released on 1960 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Performance of a Mach Number 3.0 Design Axisymmetric Double-cone External-compression Inlet in the Mach Number Range 1.97 to 0.79 by : Owen H. Davis
Download or read book Performance of a Mach Number 3.0 Design Axisymmetric Double-cone External-compression Inlet in the Mach Number Range 1.97 to 0.79 written by Owen H. Davis and published by . This book was released on 1960 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Investigation of a Mixed-compression Axisymmetric Inlet System at Mach Numbers 0.6 to 3.5 by : Donald B. Smeltzer
Download or read book Investigation of a Mixed-compression Axisymmetric Inlet System at Mach Numbers 0.6 to 3.5 written by Donald B. Smeltzer and published by . This book was released on 1970 with total page 252 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Investigation of a Mixed Compression Axisymmetric Inlet at Mach Number 5.3 by : Eldon A. Latham
Download or read book Investigation of a Mixed Compression Axisymmetric Inlet at Mach Number 5.3 written by Eldon A. Latham and published by . This book was released on 1972 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Tests of a Mixed Compression Axisymmetric Inlet with Large Transonic Mass Flow at Mach Numbers 0.6 to 2.65 by : Donald B. Smeltzer
Download or read book Tests of a Mixed Compression Axisymmetric Inlet with Large Transonic Mass Flow at Mach Numbers 0.6 to 2.65 written by Donald B. Smeltzer and published by . This book was released on 1972 with total page 196 pages. Available in PDF, EPUB and Kindle. Book excerpt: A 38.8-cm (15.28-in.) capture diameter model of a mixed-compression axisymmetric inlet system with a translating cowl was designed and tested. The internal contours, designed for Mach number 2.65, provided a throat area of 59 percent of the capture area when the cowl was retracted for transonic operation. Other model features included a boundary-layer removal system, vortex generators, an engine airflow bypass system, cowl support struts, and rotating rakes at the engine face. All tunnel testing was conducted at a tunnel total pressure of about 1 atm (a unit Reynolds number of about 8.53 million/m at Mach number 2.65) at angles of attack from 0 deg to 4 deg. Results for the following were obtained: total-pressure recovery and distortion at the engine face as a function of bleed mass-flow ratio, the effect of bleed and vortex generator configurations on pressure recovery and distortion, inlet tolerance to unstart due to changes in angle of attack or Mach number, surface pressure distributions, boundary-layer profiles, and transonic additive drag. At Mach number 2.65 and with the best bleed configurations, maximum total pressure recovery at the engine face ranged from 91 to 94.5 percent with bleed mass-flow ratios from 4 to 9 percent, respectively, and total-pressure distortion was less than 10 percent. At off-design supersonic Mach numbers above 1.70, maximum total-pressure recoveries and corresponding bleed mass flows were about the same as at Mach number 2.65, with about 10 to 15 percent distortion. In the transonic Mach number range, total pressure recovery was high (above 96 percent) and distortion was low (less than 15 percent) only when the inlet mass-flow ration was reduced 0.02 to 0.06 from the maximum theoretical value (0.590 at Mach number 1.0).
Book Synopsis Computer Program for Design And/or Analysis of Two-dimensional and Axisymmetric Inlets by : Larry K. Ratliff
Download or read book Computer Program for Design And/or Analysis of Two-dimensional and Axisymmetric Inlets written by Larry K. Ratliff and published by . This book was released on 1979 with total page 164 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis A Comparison of the Performance of Four Side-mounted Inlets Over a Mach Number Range of 0.88 to 2.2 and Angles of Attack to 14° by : Leroy L. Presley
Download or read book A Comparison of the Performance of Four Side-mounted Inlets Over a Mach Number Range of 0.88 to 2.2 and Angles of Attack to 14° written by Leroy L. Presley and published by . This book was released on 1960 with total page 58 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Experimental Dynamic Response of a Two-dimensional, Mach 2.7, Mixed-compression Inlet by : Robert J. Baumbick
Download or read book Experimental Dynamic Response of a Two-dimensional, Mach 2.7, Mixed-compression Inlet written by Robert J. Baumbick and published by . This book was released on 1972 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt: A test program was conducted on a two-dimensional supersonic inlet. Internal disturbances in diffuser exit mass flow were produced by oscillating overboard bypass doors. Open-loop dynamic responses of shock position, throat exit and diffuser exit static pressures are presented. The steady-state and dynamic coupling between ducts were also obtained. The experimental results from the two-dimensional inlet are compared to results from a similar size axisymmetric inlet and also to a transfer function synthesis program.
Book Synopsis Performance of External-compression Bump Inlet at Mach Numbers of 1.5 to 2.0 by : Paul C. Simon
Download or read book Performance of External-compression Bump Inlet at Mach Numbers of 1.5 to 2.0 written by Paul C. Simon and published by . This book was released on 1957 with total page 46 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Performance of a Mach 3.0 External-internal- Compression Axisymmetric Inlet at Mach Numbers from 2.0 to 3.5 by :
Download or read book Performance of a Mach 3.0 External-internal- Compression Axisymmetric Inlet at Mach Numbers from 2.0 to 3.5 written by and published by . This book was released on 1960 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis PERFORMANCE SUMMARY AND ANALYSIS OF A MACH 3.0 DESIGN AXISYMMETRIC ALL-EXTERNAL-COMPRESSION DOUBLE-CONE INLET FROM MACH NUMBER 3.0 TO 0.8 by :
Download or read book PERFORMANCE SUMMARY AND ANALYSIS OF A MACH 3.0 DESIGN AXISYMMETRIC ALL-EXTERNAL-COMPRESSION DOUBLE-CONE INLET FROM MACH NUMBER 3.0 TO 0.8 written by and published by . This book was released on 1960 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt: