The Amateur Mechanics Workshop By The Author Of The Lathe And Its Uses

Author : James Lukin
Publisher : Rarebooksclub.com
ISBN 13 : 9781230191980
Total Pages : 48 pages
Book Rating : 4.1/5 (919 download)

DOWNLOAD NOW!

Download or read book The Amateur Mechanic's Workshop, by the Author of the Lathe and Its Uses written by James Lukin and published by Rarebooksclub.com. This book was released on 2013-09 with total page 48 pages. Available in PDF, EPUB and Kindle. Book excerpt: This historic book may have numerous typos and missing text. Purchasers can usually download a free scanned copy of the original book (without typos) from the publisher. Not indexed. Not illustrated. 1870 edition. Excerpt: ...with a 3in. crank and used with a treadle, being heavy enough to continue in motion, notwithstanding the pressure of the tool, even when the latter is a broad plane-iron. It is necessary to use water; consequently, the stone must have a trough beneath, and this should be hinged at the further end so that it can be elevated by a wedge beneath, or suspended at the free end. The water poured into this can thus be raised to touchu the stone when in use, and lowered out of contact when the grinding is finished. The stone must not be left to soak in the water. Attached to the frame of the grindstone, and capable of some little adjustment as to height and distance, must be a strong rest of wood or ironu to assist in supporting and keeping the tool firmly in position. The Fig. 99, from Holtzapffel, will show at once the best form of mounted grindstone for the amateur's use, although he may fit up one on a similar plau at a considerably lower price than is charged for the one shown. Let it be observed, however, that a stone badly mounted, and which does not run truly, is not only a disgrace to the owner but absolutely useless. The greatest care, therefore, should be used in first setting it up and in afterwards keeping it in order. If the amateur can spare time and a few extra shillings, let him by all means discard the clumsy square axle and wedges. Let the central hole be plugged with a piece of boxwood bored truly at right angles with the flat face of the stone with an augur, and let FIG.100 the round axle be made with a fixed and a movable flange, as in the Fig. 100, where A is the stone, B the axle, with flange (0) fixed, and a second (D) made with a central hole, to enable it to be screwed against the stone by the nut E. F F are washers of...