A Study Of The Permeability Capillary Pressure Relationship In Core Samples

Author : Morteza Akbarabadi
Publisher :
ISBN 13 : 9781303809415
Total Pages : 152 pages
Book Rating : 4.8/5 (94 download)

DOWNLOAD NOW!

Download or read book An Experimental Study of Relative Permeability Hysteresis, Capillary Trapping Characteristics, and Capillary Pressure of CO2/brine Systems at Reservoir Conditions written by Morteza Akbarabadi and published by . This book was released on 2013 with total page 152 pages. Available in PDF, EPUB and Kindle. Book excerpt: We present the results of an extensive experimental study on the effects of hysteresis on permanent capillary trapping and relative permeability of CO2 /brine and supercritical (sc)CO2 +SO2 /brine systems. We performed numerous unsteady- and steady-state drainage and imbibition full-recirculation flow experiments in three different sandstone rock samples, i.e., low and high-permeability Berea, Nugget sandstones, and Madison limestone carbonate rock sample. A state-of-the-art reservoir conditions core-flooding system was used to perform the tests. The core-flooding apparatus included a medical CT scanner to measure in-situ saturations. The scanner was rotated to the horizontal orientation allowing flow tests through vertically-placed core samples with about 3.8 cm diameter and 15 cm length. Both scCO2 /brine and gaseous CO2 (gCO2 )/brine fluid systems were studied. The gaseous and supercritical CO2 /brine experiments were carried out at 3.46 and 11 MPa back pressures and 20 and 55°C temperatures, respectively. Under the above-mentioned conditions, the gCO2 and scCO2 have 0.081 and 0.393 gr/cm3 densities, respectively. During unsteady-state tests, the samples were first saturated with brine and then flooded with CO2 (drainage) at different maximum flow rates. The drainage process was then followed by a low flow rate (0.375 cm3 /min) imbibition until residual CO2 saturation was achieved. Wide flow rate ranges of 0.25 to 20 cm3 /min for scCO2 and 0.125 to 120 cm3 min for gCO2 were used to investigate the variation of initial brine saturation (S [subscript] wi ) with maximum CO2 flow rate and variation of trapped CO2 saturation (S [subscript] CO 2 [subscript] r ) with Swi . For a given Swi , the trapped scCO2 saturation was less than that of gCO2 in the same sample. This was attributed to brine being less wetting in the presence of scCO2 than in the presence of gCO2 . During the steady-state experiments, after providing of fully-brine saturated core, scCO was injected along with brine to find the drainage curve and as a consequence the S [subscript] wi , then it was followed by the imbibition process to measure S [subscript] CO2 [subscript] r . We performed different cycles of relative permeability experiments to investigate the effect of hysteresis. The S [subscript] wi and S [subscript] CO 2r varied from 0.525 to 0.90 and 0.34 to 0.081, respectively. Maximum CO2 and brine relative permeabilities at the end of drainage and imbibition and also variation of brine relative permeability due to post-imbibition CO2 dissolution during unsteady-state experiment were also studied. We co-injected SO2 with CO2 and brine into the Madison limestone core sample. The sample was acquired from the Rock Springs Uplift in southwest Wyoming. The temperature and pressure of the experiments were 60°C and 19.16 MPa, respectively. Each drainage-imbibition cycle was followed by a dissolution process to establish S [subscripti] w =1. The results showed that about 76% of the initial CO2 was trapped by capillary trapping mechanism at the end of imbibition test. We also investigated the scCO2 +SO2 /brine capillary pressure versus saturation relationship through performing primary drainage, imbibition, and secondary drainage experiments. The results indicated that the wettability of the core sample might have been altered owing to being in contact with the scCO2+SO2 /brine system. During primary drainage CO2 displaced 52.5% of brine, i.e., S [subscript] wi = 0.475. The subsequent imbibition led to 0.329 CO2 saturation. For all series of experiments, the ratio of S [subscript] CO2r to initial CO2 saturation (1- S [subscript] wi ) was found to be much higher for low initial CO2 saturations. This means that greater fractions of injected CO2 can be permanently trapped at higher initial brine saturations. The results illustrated that very promising fractions (about 49 to 83 %) of the initial CO2 saturation can be trapped permanently. (Abstract shortened by UMI.)