Read Books Online and Download eBooks, EPub, PDF, Mobi, Kindle, Text Full Free.
Oil Water Separator Test And Evaluation
Download Oil Water Separator Test And Evaluation full books in PDF, epub, and Kindle. Read online Oil Water Separator Test And Evaluation ebook anywhere anytime directly on your device. Fast Download speed and no annoying ads. We cannot guarantee that every ebooks is available!
Book Synopsis Oil/Water Separator Test And Evaluation by :
Download or read book Oil/Water Separator Test And Evaluation written by and published by . This book was released on 1995 with total page 278 pages. Available in PDF, EPUB and Kindle. Book excerpt: Four oil/water separators were tested in 1992 in a project jointly sponsored by the U.S. Coast Guard R & D Center and the Marine Spill Response Corporation. The objective of the test program was to evaluate the performance of oil/water separators under a variety of conditions that replicated operating conditions expected during an offshore oil spill recovery operation. The separators tested were the Alfa-Laval OFPX 413 disk-stack centrifuge. Conoco Specialty Products' Vortoil Oilspill Separation System, International Separation Technology's Intr-Septor 250 and a simple gravity tank. Separation performance was documented for a range of influent oil/water ratios, using crude and a water-in-oil emulsion. Simulated sea motion, the addition of emulsion breaker, and debris in the influent were other variables included in the test program. Observations on separator operability, reliability, maintenance requirements, safety and transportability also were documented. Complete test results and analysis are included in the report. Recommended system improvements, based on manufacturers' input and performance analysis also are included. Test methods and parameters are fully documented in the report.
Book Synopsis Test and Evaluation of a 50-Gallon-Per-Minute Oil/Water Separator (Separation and Recovery Systems, Inc.). by : Edward C. Russell
Download or read book Test and Evaluation of a 50-Gallon-Per-Minute Oil/Water Separator (Separation and Recovery Systems, Inc.). written by Edward C. Russell and published by . This book was released on 1972 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report covers the test and evaluation of a Separation and Recovery Systems, Inc. (SRS), 50-gallon-per-minute (gpm) oil/water separation system to determine its suitability as a shipboard oil-pollution control device. This report concludes that: The SRS, 50-GPM oil/water separator should be considered a candidate for further detailed testing to confirm its suitability as a first-generation oil/water separation system for shipboard use. Rigid qualification tests and quality conformance or acceptance tests and procedures should be established and followed by the procuring activities to insure that only usable elements are accepted from the manufacturers for issue to the users. Additional effort by Government and industry is required to develop the analytical techniques and equipment vitally needed for the accurate, reliable detection and measurement of oil in water. (Modified author abstract).
Book Synopsis Test and Evaluation of Oil/water Separators by : M. Fickel
Download or read book Test and Evaluation of Oil/water Separators written by M. Fickel and published by . This book was released on 1996 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Oil/water Separator Evaluation by : John Mittleman
Download or read book Oil/water Separator Evaluation written by John Mittleman and published by . This book was released on 1975 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt: A coalescing, plate-type, oil-water separator was evaluated. One series of tests involved separating Navy Special Fuel Oil from seawater. A permanent emulsion of seawater in NSFO formed in the closed loop experiment set-up, and required termination of these tests. Another series of tests involved separating contaminated Navy Distillate from seawater. These tests were successfully completed. Field experience indicated that the coalescing plate configuration could separate ND out of seawater, producing a water effluent containing approximately 200 ppm oil, and an oil effluent containing less than 5 percent water. However, the reliability of the separator's automatic mode was unsatisfactory. (Author).
Book Synopsis Test and Evaluation of Oil Water Separation Systems by : Anker V. Sims
Download or read book Test and Evaluation of Oil Water Separation Systems written by Anker V. Sims and published by . This book was released on 1972 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt: A test program was performed to evaluate the performance of individual oil-water separation devices and a series combination of those devices. Twenty-seven test runs were made to evaluate four oil-water separating devices and a combined unit consisting of three of the devices in series. The Heil parallel plate gravity separator was tested in a series of five runs using a seawater feed containing varying amounts of a mixed oil feed consisting of varying ratios of Navy Special Fuel Oil (NSFO) and Navy Slops. The Fram Coalescing Filter separator was tested in a series of seven runs using a seawater feed containing varying amounts of NSFO. The SRS separator was tested in a series of four runs using a seawater feed containing varying amounts of NSFO. A Carbon Column was tested in a series of seven runs using a seawater-oil emulsion containing varying amounts of NSFO and one of three surfactants. Four test runs were made on a combined unit consisting of the Heil separator, the SRS separator, and the Carbon Column in series. Feed was seawater, at 20 gpm, containing varying amounts of a mixed feed consisting of NSFO, slops, and surfactant. Performance in terms of oil and surfactant removal was satisfactory. (Author).
Book Synopsis Test Plan for the Shoreside Evaluation of Oil/water Separators by : G. E. Mitchell
Download or read book Test Plan for the Shoreside Evaluation of Oil/water Separators written by G. E. Mitchell and published by . This book was released on 1974 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt: A guide for developing test procedures for testing oil/water separators in the Maritime Administration's NMRC-Galveston Oil/Water Separation Test Loop.
Book Synopsis Oil/water Separator Test and Evaluation by : Michele A. Murdoch
Download or read book Oil/water Separator Test and Evaluation written by Michele A. Murdoch and published by . This book was released on 1995 with total page 284 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Separation and Recovery Systems, Inc., 100-Gallon-per-Minute Oil/Water Separator by : Edward C. Russell
Download or read book Separation and Recovery Systems, Inc., 100-Gallon-per-Minute Oil/Water Separator written by Edward C. Russell and published by . This book was released on 1973 with total page 27 pages. Available in PDF, EPUB and Kindle. Book excerpt: The report covers the test and evaluation of a Separation and Recovery Systems, Inc. (SRS), 100-gallon-per-minute (gpm) oil/water separation system to determine its suitability as a shipboard oil pollution control device. (Modified author abstract).
Book Synopsis Fram Corporation Model OWS-23-FCI-USCG Oil/Water Separator by : Edward C. Russell
Download or read book Fram Corporation Model OWS-23-FCI-USCG Oil/Water Separator written by Edward C. Russell and published by . This book was released on 1973 with total page 17 pages. Available in PDF, EPUB and Kindle. Book excerpt: The report covers the test and evaluation of a Fram Corporation Model OWS-23-FCI-USCG oil/water separator to determine its suitability as a shipboard oil pollution control device. The device uses gravity separation to remove free and unemulsified oil from water. Based on an evaluation of the test results, degree of conformance to the general test goals, and performance relative to the performance of other separators evaluated during the program, this report concludes that the separator should be considered a candidate for further detailed testing to confirm its suitability as a first-generation oil/water separation system for shipboard use.
Book Synopsis Test and Evaluation of Oil/Water Separators: Intr-Septor 250 and FRAMO 'Skimmer Separator'. by :
Download or read book Test and Evaluation of Oil/Water Separators: Intr-Septor 250 and FRAMO 'Skimmer Separator'. written by and published by . This book was released on 1996 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report presents the results of testing two candidate Oil/Water Separator (OWS) units. The tests were planned and directed by the Naval Facilities Engineering Service Center (NFESC) at Port Hueneme, California, under joint sponsorship and funding from the United States Coast Guard Research and Development Center and the Marine Spill Response Corporation. The 'Intr-Septor 250' was a repeat performer, having been modified as a result of similar tests conducted by the Navy in 1992. The second candidate, the FRAMO 'Skimmer Separator, ' arrived as a prototype machine, having recently been assembled and put through shakedown tests by the manufacturer. Each unit was subjected to a comprehensive sequence of tests that included the processing of various percentages of test oil in water and oil/water emulsion in free water (with and without emulsion breaker). In addition, tests that included the passage of entrained debris were completed to establish a baseline for performance under conditions conducive to clogging the OWS. In summary, although each machine was successful in effectively separating oil from water at particular inlet conditions, each recorded operational 'hiccups' while performing over the full range of input characteristics that would be anticipated during an actual marine spill. The most significant deficiency was the inability to operate effectively and reliably through wide variations in percentage of waste oil and emulsion composition, and to handle ingested debris materials. In particular, the processing of heavy emulsions and slugs of particle debris appears to 'gum up' the inner workings to such a degree that partial disassembly and cleaning of small orifices was required in order to get the OWS back on line. A recommended next step in evolution is to bypass the limitations of performance inherent in machines of this size and power by improving th.
Book Synopsis Teledyne Oil/water Monitor Evaluation by : James M. Climato
Download or read book Teledyne Oil/water Monitor Evaluation written by James M. Climato and published by . This book was released on 1974 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The Teledyne model 611 oil/water monitor was evaluated for response time and sensitivity to different crude oil, refined products, and degreaser chemicals and for possible application in the MarAd Oil/Water Separator Test Installation (MOSTI).
Book Synopsis OHMSETT Evaluation Tests by : Douglas J. Graham
Download or read book OHMSETT Evaluation Tests written by Douglas J. Graham and published by . This book was released on 1980 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Oil/water separation by : Fidelis A. Osamor
Download or read book Oil/water separation written by Fidelis A. Osamor and published by . This book was released on 1978 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Testing and Evaluation of Oil Spill Recovery Equipment by : Maine Port Authority (Portland, Me.)
Download or read book Testing and Evaluation of Oil Spill Recovery Equipment written by Maine Port Authority (Portland, Me.) and published by . This book was released on 1971 with total page 174 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Book Synopsis Test and Evaluation of Oil Pollution Abatement Devices for Shipboard Use, Phase III. by : L. B. Norton
Download or read book Test and Evaluation of Oil Pollution Abatement Devices for Shipboard Use, Phase III. written by L. B. Norton and published by . This book was released on 1973 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt: A 100 GPM filter/coalescer oily water separator system designed for both bilge and ballast service was installed on a 210 ft. Medium Endurance U.S. Coast Guard cutter. The separator water effluent was monitored by an on-line infra-red absorption type monitor. The alarm points were set to recirculate water effluents exceeding 20 milligrams/liter (MG/L). Bilge mixtures were processed both at sea and in port. Normal water effluent oil concentrations were 12 to MG/L. Ballast mixtures were processed in port. A maximum of 5 MG/L was discharged overboard during this procedure. A soap-like substance was accidentally processed while in port. The mixture could not be adequately separated to permit discharge overboard. All other emulsions were separated satisfactorily. (Modified author abstract).
Book Synopsis Feasibility Test Program of Application of Coalescing Phase Oil/Water Separators to Self Compensating Fuel Tanks in Surface Ships by : J. B. Arnaiz
Download or read book Feasibility Test Program of Application of Coalescing Phase Oil/Water Separators to Self Compensating Fuel Tanks in Surface Ships written by J. B. Arnaiz and published by . This book was released on 1974 with total page 90 pages. Available in PDF, EPUB and Kindle. Book excerpt: The report covers the evaluation of the General Electric Coalescing Plate Oil/Water Separator concept as applied to ballast water discharged from a ship equipped with self compensating fuel tanks during fueling operations. It was used to remove the entrained fuel oil from de-ballasted water being discharged during routine fueling operations. This separator was chosen because it has a cross sectional area and volume very nearly equivalent to a DE-1040 forward fuel tank. By attaching the separator directly to the ship's discharge port and refuelling at several flow rates it was possible to evaluate the performance of the coalescing plate banks in a de-ballasting operation.
Book Synopsis OPC-3000 Coalescing Plate Oil/Water Separator Evaluation by : John Mittleman
Download or read book OPC-3000 Coalescing Plate Oil/Water Separator Evaluation written by John Mittleman and published by . This book was released on 1977 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt: An oil/water separator for deballasting applications was designed and fabricated by Naval Coastal Systems Laboratory under Navy contract. Designated OPC-3000, the separator is in use at the Craney Island Fuel Depot, Portsmouth, Va. The separator's coalescing plate and foam design and system installation at CIFD are described. The results of performance evaluations between May and October 1977 are reported.
