Strength Of Webs Of I Beams And Girders

Author : Herbert F. Moore
Publisher :
ISBN 13 : 9781332240883
Total Pages : 60 pages
Book Rating : 4.2/5 (48 download)

DOWNLOAD NOW!

Download or read book Strength of Webs of I-Beams and Girders (Classic Reprint) written by Herbert F. Moore and published by . This book was released on 2015-08-05 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from Strength of Webs of I-Beams and Girders 1. Preliminary. - In designing beams and girders it is usual to consider that the bending action is resisted by the flanges, and the shearing stress by the web. There is a tendency, however, for webs of deep girders to fail by buckling; and there are complex stresses set up at the junction of the web and flange. There are also crushing stresses in the web over the supports of the girder or under the points of application of concentrated loads. When a girder is subjected to flexure the material on one side of the neutral axis is subjected to longitudinal tensile stresses and the material on the other side is subjected to longitudinal compressive stresses. The material at any point in the girder is also subjected to longitudinal and to transverse shearing stresses of equal intensity. The longitudinal tensile and compressive stresses arc equal to zero at the neutral axis and increase to a maximum at the outer edges of the flanges. The shearing stresses arc equal to zero at the outer edges of the flanges and increase to a maximum at the neutral axis. Since the shearing stress is equal to zero at the outer edge of the girder the flange carries little and the web practically all of the shear on a transverse section. In the design of a girder the longitudinal stress in the outer edge of the flange is limited to a safe value for the material in tension or compression, and the average shearing stress in the web (obtained by dividing the maximum total shear upon a transverse section by the cross-sectional area of the web) is kept within safe limits for the material in shear. Although, according to the elastic theory of beams, points intermediate between the neutral axis and the outer edge of the flange arc subjected to both longitudinal tension or compression and to transverse and longitudinal shear, and although it is known that these combined stresses result in diagonal tensile (or compressive) and shearing stresses which are greater than the component stresses producing them, these diagonal stresses are not considered in the design of the girder. The view has been held that the diagonal tensile or compressive stresses do not materially exceed the simple longitudinal stress at the outer edge of the flange, and that the diagonal shearing stress does not materially exceed the shearing stress at the neutral axis. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.