Read Books Online and Download eBooks, EPub, PDF, Mobi, Kindle, Text Full Free.
Download Heat Transfer And Pressure Measurements On Flat Faced Flared Tail Circular Cylinders And Normal Disks full books in PDF, epub, and Kindle. Read online Heat Transfer And Pressure Measurements On Flat Faced Flared Tail Circular Cylinders And Normal Disks ebook anywhere anytime directly on your device. Fast Download speed and no annoying ads. We cannot guarantee that every ebooks is available!
Author :
Publisher :
ISBN 13 :
Total Pages : 0 pages
Book Rating : 4.:/5 (227 download)
Download or read book Heat-transfer and Pressure Measurements on Flat-faced Flared-tail Circular Cylinders and Normal Disks written by and published by . This book was released on 1959 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author : A. J. CHONES
Publisher :
ISBN 13 :
Total Pages : 1 pages
Book Rating : 4.:/5 (227 download)
Download or read book Heat-transfer and Pressure Measurements on Flat-faced Flared-tail Circular Cylinders and Normal Disks written by A. J. CHONES and published by . This book was released on 1959 with total page 1 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author : J. Leith Potter
Publisher :
ISBN 13 :
Total Pages : 26 pages
Book Rating : 4.3/5 (91 download)
Download or read book Experimental Heat Transfer to Blunt Axisymmetric Bodies Near the Limit of Continuum Flow written by J. Leith Potter and published by . This book was released on 1962 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt: Measurements of average heat-transfer rates to blunt-nosed, axisymmetric, cold-walled bodies in a low-density, hypervelocity wind tunnel are given. Stream density was such that Reynolds and Knudsen numbers, based on nose radius and conditions immediately behind the bow shock, varied from 5 to 20 and 0.11 to 0.056, respectively. Thus, scaling on the basis of Knudsen number, these conditions may be said to simulate a body of one-foot nose radius at as much as 315,500-ft altitude. Heat-transfer rates are discussed in relation to the flow model successfully used in the past for studies of flows of high Reynolds number. In this context, it was found that measured heat-transfer rates to hemispheres below shock-layer Reynolds numbers of 20 exhibited a decreasing nondimensionalized rate relative to that estimated by methods appropriate to high Reynolds number conditions. This behavior is in accord with various applicable theories. Rates for the flat-faced bodies showed no tendency to decrease, and they were somewhat higher than predicted by theories for high Reynolds numbers.
Author : A. B. Bailey
Publisher :
ISBN 13 :
Total Pages : 72 pages
Book Rating : 4.3/5 (91 download)
Download or read book The Shock Shape and Shock Detachment Distance for Spheres and Flat-faced Bodies in Low-density, Hypervelocity, Argon Flow written by A. B. Bailey and published by . This book was released on 1963 with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt: An experimental investigation was made to determine the pressure distribution, shock shape, and shock detachment distance for spheres and the latter two characteristics for flatfaced bodies in a heated argon flow. The modified Newtonian approximation for the pressure distribution, which is strictly an empirical relationship, gives good results when applied to the first 60 degrees of a hemisphere under conditions where the body boundary layer and the shock layer merge. The natural flow visualization produced as a result of the high total temperature and consequent excitation of the argon enabled this study to be made. Photographs taken of the shocks generated by a series of spheres and flat-faced bodies were analyzed with a photo-densitometer to determine the shock shape and shock detachment distance. The blast analogy predicts a difference in the shape of shocks in argon and air at high Mach numbers and Reynolds numbers. An empirical relationship proposed by Love was used to calculate the shock shape in air for Mach numbers corresponding to those of the present investigation. (Author).
Author : Paige B. Burbank
Publisher :
ISBN 13 :
Total Pages : 30 pages
Book Rating : 4.:/5 (317 download)
Download or read book Heat-Transfer and Pressure Measurements on a Flat-Face Cylinder at a Mach Number Range of 2.49 to 4.44 written by Paige B. Burbank and published by . This book was released on 1959 with total page 30 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author : Michał Lunc
Publisher : Elsevier
ISBN 13 : 1483184323
Total Pages : 613 pages
Book Rating : 4.4/5 (831 download)
Download or read book Propulsion Re-Entry Physics written by Michał Lunc and published by Elsevier. This book was released on 2014-05-09 with total page 613 pages. Available in PDF, EPUB and Kindle. Book excerpt: Propulsion Re-Entry Physics deals with the physics of propulsion re-entry and covers topics ranging from inductive magnetoplasmadynamic (MPD) propulsion systems to launch systems and orbiting maneuvering systems. Problems of re-entry aerodynamics are considered, along with interaction problems in hypersonic fluid dynamics. Comprised of 31 chapters, this volume begins with a detailed account of the quasi-steady adiabatic vaporization and subsequent exothermic decomposition of a pure monopropellant spherical droplet in the absence of free and forced convection. The discussion then turns to results of calculations on MPD machines working in the intermittent and in the continuous mode; inductive plasma accelerators with electromagnetic standing waves; and spherical rocket motors for space and upper stage propulsion. Subsequent chapters focus on pulsed plasma satellite control systems; drag and stability of various Mars entry configurations; hypersonic laminar boundary layers around slender bodies; and effects of an entry probe gas envelope on experiments concerning planetary atmospheres. This book will appeal to students, practitioners, and research workers interested in propulsion re-entry and the accompanying physics.
Author : Heat Transfer and Fluid Mechanics Institute
Publisher :
ISBN 13 :
Total Pages : 312 pages
Book Rating : 4.3/5 (91 download)
Download or read book Proceedings of the Heat Transfer and Fluid Mechanics Institute written by Heat Transfer and Fluid Mechanics Institute and published by . This book was released on 1962 with total page 312 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author :
Publisher :
ISBN 13 :
Total Pages : 620 pages
Book Rating : 4.:/5 (39 download)
Download or read book Propulsion re-entry physics written by and published by . This book was released on 1970 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author :
Publisher :
ISBN 13 :
Total Pages : 432 pages
Book Rating : 4.:/5 (319 download)
Download or read book Aeronautical Report written by and published by . This book was released on 1962 with total page 432 pages. Available in PDF, EPUB and Kindle. Book excerpt:
![Download Heat-transfer and Pressure Measurements on Flat-face Cylinder at Mach Number Range of 2.49 to 4.44 [with List of References] PDF Online Free](https://books.google.com/books/content/images/frontcover/yPcjzQEACAAJ?fife=w200-h370)
Author :
Publisher :
ISBN 13 :
Total Pages : 24 pages
Book Rating : 4.:/5 (979 download)
Download or read book Heat-transfer and Pressure Measurements on Flat-face Cylinder at Mach Number Range of 2.49 to 4.44 [with List of References] written by and published by . This book was released on 1959 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author :
Publisher :
ISBN 13 :
Total Pages : 620 pages
Book Rating : 4.:/5 (35 download)
Download or read book Proceedings written by and published by . This book was released on 1970 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author : William E. Stoney
Publisher :
ISBN 13 :
Total Pages : 38 pages
Book Rating : 4.:/5 (25 download)
Download or read book Heat-transfer and Pressure Measurements on Flat-faced Cylinders at a Mach Number of 2 written by William E. Stoney and published by . This book was released on 1958 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt: Flat-faced cylinders of 12-inch dtameter and 4-inch diameter were tested at a Mach number of 2 and sea-level conditions in the preflight jet of the Langley Pilotless Aircraft Research Station at Wallops Island, Va. Both pressure distributions and heat-transfer rates were measured.
Author : C. C. Horstman
Publisher :
ISBN 13 :
Total Pages : 80 pages
Book Rating : 4.:/5 (227 download)
Download or read book Pressure and Heat Transfer Measurements Over a Circular Cylinder at Angles of Attack Up to 15 Deg at M written by C. C. Horstman and published by . This book was released on 1963 with total page 80 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author :
Publisher :
ISBN 13 :
Total Pages : 620 pages
Book Rating : 4.:/5 (318 download)
Download or read book Comptes Rendus written by and published by . This book was released on 1970 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Author : Harold F. Giles Jr
Publisher : William Andrew
ISBN 13 : 1437734820
Total Pages : 638 pages
Book Rating : 4.4/5 (377 download)
Download or read book Extrusion written by Harold F. Giles Jr and published by William Andrew. This book was released on 2013-09-21 with total page 638 pages. Available in PDF, EPUB and Kindle. Book excerpt: The second edition of Extrusion is designed to aid operators, engineers, and managers in extrusion processing in quickly answering practical day-to-day questions. The first part of the book provides the fundamental principles, for operators and engineers, of polymeric materials extrusion processing in single and twin screw extruders. The next section covers advanced topics including troubleshooting, auxiliary equipment, and coextrusion for operators, engineers, and managers. The final part provides applications case studies in key areas for engineers such as compounding, blown film, extrusion blow molding, coating, foam, and reprocessing. This practical guide to extrusion brings together both equipment and materials processing aspects. It covers basic and advanced topics, for reference and training, in thermoplastics processing in the extruder. Detailed reference data are provided on such important operating conditions as temperatures, start-up procedures, shear rates, pressure drops, and safety. A practical guide to the selection, design and optimization of extrusion processes and equipment Designed to improve production efficiency and product quality Focuses on practical fault analysis and troubleshooting techniques
Author : J. Edward Pope
Publisher : Gulf Professional Publishing
ISBN 13 : 0884157903
Total Pages : 417 pages
Book Rating : 4.8/5 (841 download)
Download or read book Rules of Thumb for Mechanical Engineers written by J. Edward Pope and published by Gulf Professional Publishing. This book was released on 1997 with total page 417 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fluids -- Heat transfer -- Thermodynamics -- Mechanical seals -- Pumps and compressors -- Drivers -- Gears -- Bearings -- Piping and pressure vessels -- Tribology -- Vibration -- Materials -- Stress and strain -- Fatigue -- Instrumentation -- Engineering economics.
Author : United States. Flight Standards Service
Publisher :
ISBN 13 :
Total Pages : 620 pages
Book Rating : 4.3/5 ( download)
Download or read book Airframe and Powerplant Mechanics Airframe Handbook written by United States. Flight Standards Service and published by . This book was released on 1976 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt:
